When to replace the POA-LMP48 (610 301 7167) projector lamp

Sanyo POA-LMP48 (service part no 610 301 7167)
Sanyo POA-LMP48 (service part no 610 301 7167)

The life expectancy of your Sanyo POA-LMP48 (service part no 610 301 7167) lamp depends on the amount of usage and whether the air filters are cleaned on a regular basis. A build up of dust on the filters will reduce the cooling fans effectiveness and may cause the lamp to overheat.

The life of the Sanyo POA-LMP48 (service part no 610 301 7167) lamp runs anywhere from 1,000 to 3,000 hours. It’s always a good idea to keep a spare lamp on hand so you can replace the lamp immediately and not wait to use the projector.

The best type of lamp to buy is one that has been guaranteed authentic and created by approved manufacturers who use the correct parts for the lamp. Knock-off lamps use counterfeit parts that can explode inside the projector or not fit properly thereby damaging the sensitive mechanism in the projector. The initial low cost of these counterfeit lamps may end up costing you more money in the long run if your projector is ruined. Buy an authentic Sanyo POA-LMP48 (service part no 6103017167) will maintain your warranty while providing you with a manufacturer’s guarantee.

Sanyo_Video_Lamp_Replac

 

Looking for a less expensive option? Are you technically adept?  Watch our step-by-step video on replacing only the Sanyo POA-LMP48 (service part no 610 301 7167) bulb instead of the entire lamp housing.
The Sanyo POA-LMP48 (service part no 610 301 7167) can be used in the following projectors:

 

For step-by-step instructions on how to replace the Sanyo POA-LMP48 (610 301 7167)4 projector lamp, please click on your specific model listed below:

 

Sanyo PLC-XT10 projector, Sanyo POA-LMP48 service part no 610 301 7167

Click here for step-by-step instructions on how to change the Sanyo POA-LMP48 (service part no 610 301 7167) projector lamp for the Sanyo PLC-XT10 projector.

 

 

Sanyo PLC-XT15 projector, Sanyo POA-LMP48 service part no 610 301 7167

 

Click here for step-by-step instructions on how to change the Sanyo POA-LMP48 (service part no 610 301 7167) projector lamp for the Sanyo PLC-XT15 projector.

 
 
 

Prolong the life of your new Sanyo POA-LMP48 (6103017167) lamp

To maintain the life of your newly installed Sanyo POA-LMP48 (service part no 610-301-7167), follow these three suggestions:

  • Wait at least five minutes before turning the Sanyo PLC-XT10 projector off.
  • Don’t operate the projector continuously without letting it stand for at least one hour turned off every 24 hours.
  • Clean the air filters regularly so the projector won’t overheat putting undue stress on on the Sanyo POA-LMP48 (service part no 610-301-7167) lamp.

Leave A Comment?