Safety tips for your Optoma 1080p Projector

Follow these important safety and maintenance tips to keep your Optoma 1080p projector working.

 

Optoma_Maintenance_SecretsBasic Care

  • To reduce the risk of fire or electric shock, do not expose your Optoma projector to rain or excessive moisture.
  • Other than opening the lamp cover to replace the lamp, do not open or disassemble the projector. This may cause electric shock.
  • Save your eyes and avoid looking directly into the laser light on the remote control. Never point the laser light into anyone’s face or eyes since the remotes are equipped with a small Class II laser that omits radiation.

 

 

determining_factor_gain_for_projectors

Avoid the following environments:

  • Extreme temperatures whether hot, cold or humid.
  • Don’t place directly in sunlight.
  • Dusty areas with excessive dust and dirt.
  • Stay away from any appliances generating a strong magnetic field.
  • Never place in direct sunlight.

 

 

Optoma_EP747_Lamp_Replace_Lamp

Replacing Optoma Lamps

  • Please be sure to change the lamp when it shows warning messages.
  • If you leave the lamp too long it may burn out and make a loud popping sound. Should this happen, the projector will not turn on until the lamp has been replaced.
  • When changing the lamp, allow your Optoma projector to cool down. These projectors operate at extremely high heat that can cause severe burns.
  • After changing a new lamp, please reset the lamp life from OSD menu.

 

 

Optoma_EP753_projector_buttons_BL-200A_lampExtending Projector Life

 

  • Let the cooling fan run a few minutes before switching off your Optoma projector.
  • Give your projector at least one hour of downtime per day to prevent overheating.
  •  When connecting the projector to computer, please turn on the projector first.
  • Clean your air filters regularly.

 

 

projector_Air_filter_maintenanceCleaning the Optoma projector

  • Always turn off your Optoma projector before cleaning.
  •  Use a soft cloth moistened with mild detergent to clean the display housing.
  •  Leave the slots and openings on the unit provided for ventilation clear of any debris of blockages.
  •  Avoid harsh, abrasive cleaners and any waxes or solvents.

 

 

Leave A Comment?