Switch the Boxlight SP-60m projector lamp

Boxlight_SP-60m_XP60M-930_replace_projector_lamp_warningFollow this guide to switch your old Boxlight SP-60m projector lamp for a new one.

Warning messages

When the Boxlight XP60M-930 projector lamp is reaching end of life, the alarm light on the Boxlight SP-50m projector flash red. Other indications that the lamp is reaching end of life include a picture that looks dim on screen or one with faded colours.

Be sure to check the lamp life using the SERVICE menu found on the SETUP MENU. NOTE: Don’t use the projector lamp in the projector past it’s due date or it may overheat, stop working or explode causing the projector to shut down.

Buy genuine OEMBoxlight_SP-60m_XP60M-930_ projector_lamp projector lamps

Purchasing a copycat generic projector lamp can be tempting due to their low prices. However, you get what you pay for and with generics that means a long list of problems that can end up damaging your projector. When you consider all the problems cause by generic lamps, they aren’t worth the savings. Stick to an authentic OEM projector lamp and keep your Boxlight SP-60m working at its best.

Reasons to avoid generics projector lamps:

Replacing the Boxlight XP60M-930 projector lamp

Before replacing the Boxlight XP60M-930 projector lamp follow these safety tips:

  • Disconnect the power cord on the Boxlight SP-60m projector.
  • Reduce the risk of severe burns by allowing the Boxlight SP-60m projector to cool for at least 45 minutes. These projectors operate using high temperatures and you run the risk of severe burns if you don’t allow it to cool down.

Boxlight_SP-60m_XP60M-930_ projector_lamp_remove_coverStep 1: Place the projector on a soft surface and turn it over. Loosen the three screws holding the lamp unit in place.

Step 2: Carefully pull out and remove the projector lamp housing. Be careful not to bang the bulb or it can shatter. Learn what to do if the bulb has broken.

oxlight_SP-60m_XP60M-930_replace_ projector_lamp

Step 3: Insert the new Boxlight XP60M-930. Be careful not to touch the actual bulb as this can result in black spots from the oil on your hands.

Step 4: Tighten the screw on the outside of the module.

NOTE: Be sure to recycle the Boxlight XP60M-930 projector lamp as contains mercury and should not be thrown into regular garbage. Recycle it!

 

Boxlight_SP-50m_XP60M-930_ projector_lamp_reset_lamp_timer_ICONS Resetting the Boxlight SP-50m lamp counter

Once the Boxlight XP60M-930 projector lamp has been replaced, you will need to reset the lamp counter so the Boxlight SP-60m projector can accurately track the number of lamp hours remaining.

To reset the lamp hours:

Boxlight_SP-50m_XP60M-930_reset_lamp_timer

  • Plug in the power cord and press the Power switch to turn the projector back on.
  • Go to SETUP MENU.
  • Scroll down to the Reset lamp timer.
  • Press Enter.
  • This will reset the lamp hours to zero.
  • Verify that the counter was reset by pressing MENU/SELECT and viewing the counter in the STATUS menu.

Learn how to extend the life of the Boxlight SP-60m projector lamps. Check out Top tips for extending DLP projector lamp life

Interested in a green alternative?

Sanyo_replacement_just_bulbThis projector has the option of only replacing the actual bulb and re-using the plastic cage. This reduces waste and is a great way to green your projector. Watch our video to learn more.

 

 

 

Leave A Comment?